90 Degree Bevel Screwdriver Angle Screw Driver Kit | Built Supply Co

One can be used directly, and the other seven types of screwdriver bits need to replace the bit on the top of the wrench, insert it in, and rotate the handle. At the same time, it is connected to the drill bit and rotated so that the screws can be easily removed.

Package Includes

• 1 pc 480 mm angled screwdriver length;
• 1 pc 35mm replaceable screwdriver head;
• 1 pc additional handle for accurate tool guidance;
• 2 pc cross recessed drills 25mm and 28mm in length;
• 5 pc 5x0.8mm slotted screwdrivers, the lengths of which are 25mm, 28mm, 35mm, 58mm and 95mm respectively

2pcs replaceable screwdriver head

• 1 piece of the original drill can be used directly
• The other one needs to be used with a screw
• It can be used with drill bits to meet the requirements of different lengths

7 pieces of screw

• 5 types of cross drill bits length: 25mm, 28mm, 35mm, 58mm and 95mm
• 2 types slotted screwdrivers length: 25mm and 28mm

480mm angled screwdriver length

• It is used to connect the drill bit and rotate the drive to adjust the screw.

1. Replace the drill bit and insert it

• When using 7 types of screws, you need to remove the original drill bit first, hold down the handle and turn the drill head to loosen it, insert the screw, tighten the drill bit, and then you can use it directly..
• The original drill can be used directly

2. Precise tool guidance

• Hold this 480mm tool insert the additional handle for precise tool guidance

3. Rotate the handle to adjust the screw

• Align the screw and turn the handle to cause the top drill bit to rotate, so as to adjust the screw

Available from Built Supply Co — New Zealand.